![]() Thank you so much for you help, any advise would be much appreciated. Id considered the in-ceiling speakers but for various reasons went with the on-wall. different distances among speakers)?ģ) would you rather advice the free-standing solution considering placing 2 speakers every time a 7.1 content will be watched is not a big deal?Ĥ) would you rather advice for a 5.1 setup to avoid placing rear surround speakers every time? Just to update I have purchased the Monitor Audio speakers: 2 pairs Silver AMS 7G Dolby Atmos® 1 pair Silver FX 7G Surrounds 1 pair Silver 50 7G for Rears These speakers come well recommended and satisfied my wifes asthetics and approval for gloss black. a system consisting of Front Dolby and ' Surround Dolby or Back Dolby ' speakers is then fully compatible to Auro. With AVR-X4400H, AVR-X6400H and AVC-X8500H, you are able to use Dolby Atmos enabled speakers for Auro 3D 9.1 playback as well, i.e. CONS: different distances among different speakers and lower sound quality.ġ) do you see any major mistake in the placement?Ģ) do you see any major concern with the wall-mounted compact speakers setup (e.g. This 9.1 (5.1.4) configuration is then fully compatible to Auro-3D and Dolby Atmos as well as DTS:X. The Reference Player will output up to 9.1.6 channels of Atmos in both lossless (Dolby TrueHD) and lossy (Dolby AC-4) flavors. CONS: rear surround speakers will be placed only when 7.1 content requires itĢ) wall-mounted compact speakers: PRO: setup and forget kind of placement. The one piece of software required for this process to work on is the Dolby Reference Player, an advanced media player intended for quality-control/testing of Dolby Atmos mixes at the professional level. The main speakers should be placed 25-30 degrees off-axis, relative to the primary seating position. PRO: setup is very close to what Dolby suggests for a 7.1.4 Atmos speaker placements. Speaker Placement For 5.1 And 7.1 Surround Sound Systems Front Left/Right Mains Speakers. The JBL Bar 1000 offers impressive 7.1. Most of the content I watch are still in 5.1.Ģ) I would rather prefer a compact/stylish speakers setup (for surround and rear surround speakers, I have 3-way floor stand speakers to use for L and R channels) vs a better sounding/bigger bookshelf speakers.Īs you can see at the end of the document attached, I'm evaluating 2 options:ġ) free-standing speakers. Considering the size of the room I would setup 7.1 speakers, but I would not discard the possibility for a 5.1 setup.Ī couple of restrictions/preferences from my (and my wife) side:ġ) I can't have rear surround speakers always in place (they will stand too close to the dining table) I will position them when a 7.1 movie requires it (one or two times a week). by 14 ft.) is a living/dining/kitchen room, so it will not be fully dedicated to the home theatre. I've been studying the dolby/atmos speakers placement guide and reading quite a lot setups on this forum, and finally did some drawing to understand which setup fits better in my room. I'm planning to move to a bigger apartment and evaluating to build my first home theatre setup. The Dolby Atmos theater installation guide PDF suggests that in a 7.1.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |